Name: TANQ 2 Flying Car Print Set
SKU: 581949

TANQ 2 Flying Car Print Set

$ 40.00

$ 50.00

Title:

DefaultTitle

Unavailable

Please select combo product attributes

The combo subtotal is $,SAVE$

Our 3D prints are designed and printed by , if you want custom colors of our prints you can contact them directly.

Turn your TANQ 2 into a TANK!

From Let's Fly RC:

"If you own a Rotor Riot TanQ 2 frame in standard configuration, will help you to turn it into a flying car. I have added Screenshots of the Radio Settings in my Zorro, so if you have Edge TX or Open TX and mirror these settings, it will be a good start. Channel 7 is the left 2 wheels, and Channel 8 is the Right two wheels, or vice versa, I don't remember.

On the ESC, I twisted the signal wires together for the left 2 motors and soldered them to the Motor 5 output wire harness on the flight controller, remapped it to servo 1, and I did the same for the right side on the Motor 6 output of the flight controller, and remapped it to servo 2 (or vice versa, I don't remember).

I used the Tmotor Pro full featured flight controller and I will upload the dump file, which will show you how I addressed the motor pads and remapping. I enabled Servo Channel Forwarding in CLI, and set the first Servo Channel to channel 7, so that 7 and 8 would be the additional motors. Then, I output servo signals from the flight controller's motor 5 and 6 as pwm signals to the motors to make them go...

The SF switch was used on my Zorro to switch between car and drone mode."